there seems to be something wrong with this picture
good quality fitting exhaust
looks like i am going to have to go the my neighbourly exhaust manufacturer and get it re made....
bit of a pain having to pay for things twice
as you can see the angle of the middle section is way of the mark ... and also the o2 sensor hole is the wrong size
Is that who made it up for you initially? or are these ebay bargains like the ebay bargains I usually buy
Hope you get it sorted mate.
Cheers
Rich
Looks like the bit with the lambda bung on needs extending about 4" and it shouldn't be too far away, oh and then just get either that
lambda plug cut out and moved or just buy another off the bay and just plug the other side up.
Looks a pretty easy thing to fix and if it looks sh1t just cover the whole thing in exhaust wrap
Cheers
Rich
Looks like a MK exhaust to me. Do you not need to put a cat in between the two pipes?
The short bit looks like a standard 30 degree bend like you can buy from Burtons.
Stu
looks like theres a bit either in the wrong order (can't see all the bits to see if thatsw actually possible though) or a bit missing, like a cat
I would say the cat is missing..
Either you have a) not been supplied with a link pipe, b) the link pipe is not included in the kit, c) there is space for an unsupplied cat, d)they
have not supplied a cat.
Only one way to find out, check the item supply list and call them up.
Looks a nice bit of kit.
Where did you get it from then?
It's a Mk supplied exhaust. I didn't think I needed to fit a cat????
You will if you intend to IVA it.
Don't have to iva it different country
Ah right, sorry. It doesnt say so in your profile and I just assumed.
quote:
Originally posted by noc231073
Don't have to iva it different country
hi nick
I have ordered you a new link pipe with less bend on it.The exhaust was coppied off my race car and the engine was 2" further
back than standard.
cheers danny
cheers danny ..... tought i was doing something wrong...................