Board logo

7"plug in shaft Diff for 7" LSD Diff
westindy - 8/3/11 at 06:58 PM

Hi, I want to replace my existing std 7"diff with plug in shafts with a LSD ( BOLT ON FLANGES ). How do I do this and keep my Drum Brakes. I am told you can replace the plug in shafts with flange CV's but my shafts are 22 spline and the Cv's available are 25 spline.
I have read a couple of articles see link but its not that easy !

http://www.carbuilders.info/pages/Sierra_Diffs

Anybody done it and can tell me how to?

Regards, Paul


snapper - 8/3/11 at 08:26 PM

You need to make a hybrid shaft using Desiel push in shafts.
You take the tripod uj off and replace with lobro CV joint.
Sierra owners club have photos and info or u2u me and I will see if I can find the info and email you.
A mate of mine has put lobro flanges in a push in diff, needs some work to get the input bearings to the right point or the stubs jam the planet gears shaft.


Pezza - 8/3/11 at 08:40 PM

Same as above, I just swapped the tripod joints for lobros and it bolted straight up to the LSD.


coozer - 9/3/11 at 11:43 AM

I did just as your intended and simply axed the caliper mounts off the bearing carriers.

Job done.


westindy - 9/3/11 at 06:24 PM

Snapper u have u2u - thanks for your help!

Cheers, Paul


ashg - 9/3/11 at 06:37 PM

quote:
Originally posted by coozer
I did just as your intended and simply axed the caliper mounts off the bearing carriers.

Job done.


love it. was thinking along the same lines when my lsd goes in. the drums work well and i cant be bothered to modify my rear uprights to run discs.