hub nut and shaft stick out just enough not to let me put my wheel centre caps on

Help needed!

You put it together right?

probably not, will take a piccy and post in asap your inspection guvnor!

here's a pic of the rear hub nut


[img][/img]

here is a pic of the wheel on the front


[img][/img]

Yeah that happened on my rears too...

space it out if you really want the covers on, or space the cover out

[Edited on 24/2/05 by macspeedy]

Yeah, I didn't fit my covers, I painted the end of the stub axle and nut silver instead.

Just grind 1/8" of end of stub and it'll fit!
Thats what i did with mine.
You'll find plenty of metal before start of thread.

Think that will work, hacksaw would take ages , i can also take the badge back off the cap and make a suitable hole in the cap ( 2mm thick ) then stick the badge back on.

Its a long shot but it might just work!

"COME BACK CHUCK"

Sorry my age is showing............ i loved them CHEWITS adverts

Yes - I had same issue on my offside rear and just took enough with an angle grinder for the centre to fit nicely!

Regards, Mark.