Hi
Does anyone know the dimensions of the MK indy fibreglass bonnet bulge. I need to cover an airbox that protrudes 2" through the bonnet and be
approx 12" wide and 18" deep.
Many Thanks in advance
- Jim
Dont know the exact dimensions, with out looking, but i know that the standard fireblade airbox for a carbed blade fits underneath if that helps.
Cheers Mike
Thanks Mike, but need to know how much gain I get over a standard bonnet as my Phoenix is probably very different to an Indy.
Cheers
- Jim
Approx 15" wide at the narrowest point (front)
18" front to back, with 2.25" clearance at the highest point, the clearance tapers off towards the edges.
Al
Jim,
I'm making one a little larger than that (20"x20" for my Fury....aiming to get the second buck done this week and the first part
pulled either at the weekend or early next week.
Stephen
Triton i believe does a few bulges
So an MK one should be ideal. I think 20" x 20" might be a little large but would like a look.
Cutting a hole in the bonnet is the one bit of my engine converstion that I am really not looking forward too. But I am determined to get the noise
down so an airbox is a must.
Triton - Any pics dimensions of your bulges - ooer missus
- Jim