Mr sva say's there too low
I have taken 2" out of the seat but still they are too low.
Asked Mr SVA (in aberdeen)about spacers and he said no I'd need to raise the anchor point
Seats are clicky
Due to having chrome cobra style rollbars I cannot easily weld in a horizontal bar like so many.
WHAT DO I DO
2" out of seatbase
Prior to Seat mod
Rollbars
[Edited on 2/707/06 by mad4x4]
[Edited on 2/707/06 by mad4x4]
[Edited on 2/707/06 by mad4x4]
[Edited on 2/707/06 by mad4x4]
Can you put some spacers to mount your harnesses higher. Mine are on bush crush tubes with M12 bolts through. Gives you about 40mm.
Steve
Are your seats on runners? could you take the runners out and bolt straight to the floor temporarily?
They look the same as the rest on the MK mounts.
Think its just the height of the seat base thats the problem, same as with the Cobra 7's they just scrape under with no runners attatched and
bolted straight to the floor.
Make a plywood and foam seat and put it through SVA with that.
Post SVA put your nice seats back in
or some fibreglass seats
http://www.locostbuilders.co.uk/viewthread.php?tid=47934
Get him to push 'Nigel' down into the seat to simulate a person sinking into the seat. My MK passed with Cobra 7s WITH runners by talking
the inspector into doing this.
TC
Hi Mate, I had the same problem and so I made this;
seat belt mod' finished/fitted
Passed SVA at Nottingham no problems.
quote:
Originally posted by JAG
Hi Mate, I had the same problem and so I made this;
seat belt mod' finished/fitted
Passed SVA at Nottingham no problems.
quote:
could it be made out of round bar?