Hi all

Any of you guy's fitted R1 bike carbs with a Bogg brothers manifold to a 2lt Pinto?

I could do with a bit of advice on aspects of the wireing for the coil and feul pump etc


Thanks

Theres a few on here whove done it.

I'm looking to do the same so will watch the thread with interest

Somebody will be along soon

Sonic has the H&H ignition fitted can you help Flak Monkey with the wiring ?
Please
Thanks Jacko

I would also be very interested in this as i have just purchased a shiny set of R1 carbs off Malc @ yorkshire engines Just have all the auxs to source now (Manifold, regulator, pump)

on my bike carb setup i have a zx9r fuel pump basically wired with a fuse to one side of the pump and the other side to earth seems to work fine.

as for the coil i have a h+h ignition system which runs vacuumless and iirc has one ig+ feed to the coil.

Thanks guy's anymore info would be great