hi all, how do you put the back panel on?

thanks

stuart

Tiger Seal from Gramics in Magdelen St Colchester.

fit it using some clamps , do some chopping and fileing until it looks ok, then i used 3 large head rivets and pu down the angled parts of the chassis which go down from roll bar ,back then a little pu along the bottom round chassis rail. once the rivets squeeze the panel in it fits ok

i got mine to fit, (which is hard on a indy lol) pu on all the inside bits, pu on the square tube behind the arches and a couple of rivits on the square tube either side.

then went under th indy and added extra pu to the round tube at the bottom and smothed it out and pressed it in to get rid of water traps.

i also pu'ed onto the fuel tank to stop vibrations

[Edited on 19/7/08 by graememk]

i got the tiger seal, what is a normally price per tube of the stuff?
as well has any body got some picyures what it is ment to llok like and how they got there?

thanks

stuart