does it need to be meshed for sva
thanking you

Mine wasn't, although it did have rubber edge trim on it.

HTH

Mike

No but the inlet should be have the 2mm radius and not sharp.

Can you imagine the test?! Like a manikins hand getting shoved down the hole! oh sorry the fingers touched something in there FAIL!

rightyo i might as well try and mesh it
but if i loose any more skin ill stick some u trim on it and hope for the best

Nope! Just rubber trim on bonnet edge exposed by scoop....

mine had no mesh or rubber trim
on the edge and there were no issues
with sva

Andy

thanks folks ive just put some u-trim on it for now.
onto my next problem mapping