I am looking for a couple of these...

Anyone know where I can get some? They are commonly used in aftermarket light units so they must be available somewhere

[Edited on 27-10-05 by RazMan]

Must be something Japanese (honda, toyota, nissan).

Greetz, Rob

do u need the wholr thing or just the b.c. bulb holder.
Is it an offset pin bulb as there are 3 wires going in but only two pins showing.

[Edited on 27/10/05 by omega 24 v6]

Hi-low beam in single bulb or brake/tail light. The third wire (black) is a common earth.

I'd say brake/tail light holder.

It's same as the rear light bulb holders in my Honda Revere.

Sorry guys, I posted that in a bit of a rush. It is from a Lexus type aftermarket rear light assembly I bought on Ebay. I want to convert the fog lights to be another pair of stop & tail (the more lights I have the better visibility) I am fitting a separate fog light for legality's sake.

Peteff - Are you sure? A Honda part sounds too easy

the bulbholder part of your photo is very very similar to what can be found in rubbolite marker lights type 50 and 51 models. It is available in scc and sbc format but i'm not sure about offset pin format.
If you can remove the centre section bulbholder part and replace it with the rubbolite one then you could solve your problem.
u2u me for more

I can't see all of the fitting on yours, the Honda one has three lugs, one a bit larger than the other two so it can only fit one way round.

I would say that was Brian

quote:

---

Originally posted by Triton
I would say that was Brian

---

Lexies are built by Toyota so I'd try a Toyo part 1st.

Iv got a pair of those sat next to me at this very moment! Don't know where you can buy them though.

Adam

but ... but ....

Would some beer vouchers pusuadw you to part with them ...... hmmmm?

quote:

---

Originally posted by The Shootist
Lexies are built by Toyota so I'd try a Toyo part 1st.

---