mk blade
|
| posted on 6/3/03 at 06:31 PM |
|
|
Fuel tank sender
Can anyone tell me which fuel tank sender fits PTM's superb plastic tanks.
Thanks guys.
ps. have posted a few pics of it so far.
|
|
|
|
|
bob
|
| posted on 6/3/03 at 07:41 PM |
|
|
I've fitted the durite dip sender and gauge kit,its the one PTM uses and cost about 35 quid all in.
It has good instructions making it a doddle to fit as well,here's the part number from durite 0-523-06 
12 V gauge and sender.
You can mail sales@durite.co.uk for nearest stockist.
http://www.durite.co.uk
|
|
|
mk blade
|
| posted on 6/3/03 at 10:33 PM |
|
|
Thanks bob
Thanks for the info bob
Will get in touch with them, not a bad price either at £35.
Is that for just sender or sender and gauge, was only looking for sender going to be making a custom dash display if all goes to plan.
|
|
|
locodude
|
| posted on 7/3/03 at 12:13 AM |
|
|
thats for both, although there are many that will fit, including sierra at a push!
|
|
|
David Jenkins
|
| posted on 7/3/03 at 08:21 AM |
|
|
I used the one from CA/Greengauges/Smiths (they're all the same company).
I think I paid around £17 - £19 for it (but I could be wrong!).
David
|
|
|
David Jenkins
|
| posted on 7/3/03 at 08:23 AM |
|
|
I should add that my tank was built to measure by PTM... so I specified the size of the hole!
David
(P.S. I would have edited my original post - but I wasn't allowed - see site problems forum!)
|
|
|
Bob da builder
|
| posted on 7/3/03 at 02:19 PM |
|
|
I got my tank from MK eng. so i guess its from PTM? any way the ETB pendulim sender fits fine, think it was about £15
p.s. There dials are very nice, would reccomend then! 
|
|
|
