mkblade
|
| posted on 2/10/06 at 11:09 PM |
|
|
rear silencer
hi all
my mk rear silencer is blowing at the tail end do i just drill out the rivets and replace with new.i was going to seal it with exhaust paste when
refitting iit all but that stuff is a bit messy .anyone done this job before ??
thansk
simon
|
|
|
|
|
Peteff
|
| posted on 3/10/06 at 09:14 AM |
|
|
You can get some high temp silicone sealant for exhaust use which might be easier to use than gun gum type stuff.
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
|
