rj
|
| posted on 3/12/07 at 12:51 PM |
|
|
cutting holes in MK seats
I want to fit 6 point harnesses to my car, and clearly need some holes in the seat base, has anyone else cut holes in MK fibreglass seats for
harnesses ?
|
|
|
|
|
Richard Quinn
|
| posted on 3/12/07 at 01:12 PM |
|
|
Not me, but I have cut plenty of other seats. It's important to weigh up the alignment of your mounting points and the holes in the seat.
You'd be amazed how effectively a harness belt will tear through a fibreglass seat shell under an accident type load! A once tight harness can
become very slack when it is no longer being being directed by the seat holes.
|
|
|
Peteff
|
| posted on 3/12/07 at 01:25 PM |
|
|
I drilled mine and joined the holes with the jigsaw from the rough side with a metal cutting blade. I put edging trim round the holes to stop rubbing.
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
|
