kurt
|
posted on 4/4/07 at 07:07 PM |
|
|
Aluminium bends, where do I get one?
I need to get a 2 3/8" or 60mm OD aluminium bend to modify an R1 can tailpipe because the MK can is too loud, it's doing my head in!
I'm getting a link pipe made up to fit it to my headers but I need an aluminium tailpipe between 45 and 90 degrees to turn it out to the side so
I don't melt my rear guard and tyre.
Cheers, Kurt
|
|
|
BenB
|
posted on 4/4/07 at 07:26 PM |
|
|
I know Merlinmotorsport can bend tubes (they can make up rollcages etc) and they stock a good selection of ali tube....
|
|
bodger
|
posted on 4/4/07 at 07:41 PM |
|
|
I spoke to Martin Keenan the other day about silencers. He's just made up a new baffled design which should be a bit quieter than the usual
cans. He's yet to test it but if it works OK then he'll be selling them his website.
|
|
RazMan
|
posted on 6/4/07 at 02:04 PM |
|
|
I got all of my 70mm bends on ebay
Cheers,
Raz
When thinking outside the box doesn't work any more, it's time to build a new box
|
|