Dear All,

I am trying to fit my cycle wing stays onto the cortina hubs on the three mounting points.
Problem I have is that there is limited flat surface at these point on the hub and the spacers I made are too large in diameter to get them to sit properly. I would be keen to know how others have got round this.

Ta Stu

I got this pic from somewhere (can't remember where) and have used the same method, except that I have the head of the bolt on the inside. The sequence goes something like:

Bolt head-washer-stay-washer-split washer-plain nut

then the run of the bolt

then plain nut-washer-hub carrier (htreaded hole)

I think I will have to cover up the bolt threads with something like heater tubing
Rescued attachment Wing stay mounts.jpg

Rescued attachment wingstays2.jpg

I used 13mm tube to fill in the gaps, welded to the back of 3mm plate
Rescued attachment Stays.JPG