snakebelly
|
| posted on 27/10/12 at 05:41 PM |
|
|
Avon / GTA Gearbox option
Well finally settled on a gearbox today for the new incaarnation of good old 99, Getrag G260, commonly found in BMW's ours is from a 525. Its a
tight squeeze but will take all that we caan throw at it hopefully whereas the type 9 was a worry for our new engine choice...
and a bargain at £110, cheaper than i have seen type 9 boxes for recently. We also bought our engine :-)
|
|
|
|
|
Nickp
|
| posted on 27/10/12 at 05:57 PM |
|
|
Same box that I'm using in my Haynes. I'm setting mine right back to fit in the BM 6 pot so had to alter the chassis a bit 
|
|
|
snakebelly
|
| posted on 27/10/12 at 05:58 PM |
|
|
We wanted to use an ST225 but it just wont fit without chassis mods so am going back to a Volvo T4 1.9
|
|
|
Nickp
|
| posted on 27/10/12 at 06:14 PM |
|
|
FYI - if you turn the gearstick assembly through 180deg and mount it off the chassis instead of the box it works a treat and the stick falls to hand
|
|
|
snakebelly
|
| posted on 28/10/12 at 09:26 AM |
|
|
interesting, is the end connected to the chassis rubber bushed? if not what will happen when the gearbox moves? What bushes are those youve used to
mount the box?
|
|
|
Nickp
|
| posted on 28/10/12 at 12:11 PM |
|
|
The rear mounting point is rubber bushed but the front is currently solid mounted. I may alter this to a rubber bobbin though. I'm hoping the
engine / box won't be moving much at all as it's on 4 very stiff Land Rover engine mounts and will probably be getting an engine steady
bar too
|
|
|
jeffw
|
| posted on 28/10/12 at 02:20 PM |
|
|
So what engine are you going with to power the box?
|
|
|
snakebelly
|
| posted on 28/10/12 at 02:39 PM |
|
|
Volvo T4 1.9, stronger than the 2 litre as the liners are thicker, and the grand total of £175. Now looking for T4 dry sump kit or may have to make
our own, Going to upgrade our ECU from the current brand new and unused DTA S40 (UP For sale shortly if anyone is interested) to the S60 as it
supports full VVT control, easier than disabling the VVT. Next part is to join the gearbox and engine before dropping it in for making the engine
mounts. Going to get TTv to make a custom flywheel and convert from cable to hydraulic clutch.
|
|
|
jeffw
|
| posted on 28/10/12 at 04:01 PM |
|
|
simple then
|
|
|
snakebelly
|
| posted on 28/10/12 at 10:01 PM |
|
|
Yep
|
|
|
