starterman
|
| posted on 17/10/17 at 01:02 PM |
|
|
Which inlet manifold?
To fit twin 45s to my avaon which inlet manifold do I need. The straight one or the angled up one?
Cheers
Mike
|
|
|
|
|
Ugg10
|
| posted on 17/10/17 at 01:23 PM |
|
|
I would think straight for weber/dellorto, these need to be horizontal for the float chambers, the angles ones (upward) tend to be for bike carbs to
throttle bodies.
This assumes your engine is upright and not canted over at an angle.
---------------------------------------------------------------
1968 Ford Anglia 105e, 1.7 Zetec SE, Mk2 Escort Workd Cup front end, 5 link rear
Build Blog - http://Anglia1968.weebly.com
|
|
|
theconrodkid
|
| posted on 17/10/17 at 04:22 PM |
|
|
have a measure first, make sure nothing is going to hit the top chassis rail 
who cares who wins
pass the pork pies
|
|
|
starterman
|
| posted on 17/10/17 at 06:22 PM |
|
|
I didn't mean an angled manifold, I was more meaning the one that steps up. I think I need the straight one. Anyone got any good recommendations
as to where to get one?
Cheers
Mike
|
|
|
melly-g
|
| posted on 18/10/17 at 06:57 AM |
|
|
What engine are you using?
|
|
|
starterman
|
| posted on 18/10/17 at 07:03 AM |
|
|
Zetec blacktop
|
|
|
