ayoungman
|
| posted on 5/9/05 at 02:48 PM |
|
|
bodywork
OK, so what do you have to do to get the body to fit the chassis then ? Main areas of concern being round tube side bit and top bit near wheel
arch.
Where does the scuttle line up ? Answers please !
"just like that !"
|
|
|
|
|
Hellfire
|
| posted on 5/9/05 at 03:07 PM |
|
|
Common area for a little imagination and innovation. We did this... but each to their own!
 bigger image
HERE our's obviously isn't an Avon but most 7's are
like this. MNR Have avoideed this by having a 1 piece rear shell... but apparently a similar problem is created somewhere else - wouldn't know
myself, it's just one doing the rounds at the moment.
Regarding Scuttle - U2U Avoneer (Pat) or Carl Geldard - both good sources of information for this build.
[Edited on 5-9-05 by Hellfire]
|
|
|
Avoneer
|
| posted on 5/9/05 at 07:14 PM |
|
|
In fact, better not ask me.
Pat...
No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.
|
|
|
%20(WinCE).JPG)
