
Hi me again.
Ive got 2 questions regarding the ZX12 cooling system and speed sensor.
1, Phil’s (hellfire) website which I have used for lots of info (cheers) shows the coolant run he has used for the oil cooler is tapped into the
return from the radiator to pump pipe. Which is nice and neat and makes it quick to plumb in, but as I have the bike rad (which i am not using) it
shows that this pipe was coming from the end cap of the radiator on the ‘hot’ side. Does this mean the oil is cooled more in the car via Phil’s run
and does it still flow as good?
2, the expansion tank is tapped into the engine to radiator top hose, what type of cap is used on this tank? Is it a normal pressure release type and
what pressure has everyone used?
3, Not sure on this one, I take it the bike gets its speed signal electronically from the ecu, if so can I use this signal (maybe via a speedo healer)
for my after market speedometer and gear indicator? Is its pulse useable? It makes it easier and requires less wiring this way.
Thank you again for any tips.
Andy
quote:
Originally posted by Moorron
3, Not sure on this one, I take it the bike gets its speed signal electronically from the ecu, if so can I use this signal (maybe via a speedo healer) for my after market speedometer and gear indicator? Is its pulse useable? It makes it easier and requires less wiring this way.
Just looking thru the german workshop manual and i can see its got a speed sensor just above the sprocket. I will check if the signal is compatable
with my devices later this week.
Sounds like good news then.
