What have you guys done for the nipple on the throttle cable at the throttle body end?
I have a cable from cbs but the nipple is only any good for the pedal end.
I need a cylinder type that I can solder or screw on.

I'll have a look what I've got at work tommorow. Got a few solderless (screw) barrel nipples in a box and found one for mine in there. If you can wait for the post (probably not with your build rate!) I'll stick it in the post. u2u your address.

adrian

quote:

---

Originally posted by adithorp
I'll have a look what I've got at work tommorow. Got a few solderless (screw) barrel nipples in a box and found one for mine in there. If you can wait for the post (probably not with your build rate!) I'll stick it in the post. u2u your address.

adrian

---

i used a mountain bike cable and cover - the end with the ball on the end was filled down slighltly to fit into the appropriate slot on the carbs - for the other end i used a cbs nipple