The clutch release cylinder on my gixer 1100 engine is very close to the output shaft, meaning that if I were to put a propshaft adaptor on I would not be able to put the clutch release cylinder back on. Does anyone know if you can get a propshaft adaptor that is 4" or less in diameter as this would solve the problem?

Adam

I thought most prop adaptors were <4"

My Stuart Taylor one is 87.5mm max o/d, 61.5mm min o/d on the spline.

Cheers

Jim
Rescued attachment prop adapt.JPG

Ours look very much like that and I believe is 90mm diameter.

Thanks, they are smaller than the diff flange then, as that measures 4 1/2". You have filled me with confidence again. Was looking at changing the engine for a ZZ-R1100 engine, but now i think I will stick with it, for the time being.

Adam

P.S What is the diameter of the propshaft at the adptor end. The Actual Propshat and thr flange.

[Edited on 31/3/04 by phelpsa]

As you can seen in my pic above my bailey morris UJ flange is 87.5mm / 3.5" same size as the prop adaptor.

Are you making your own prop?

[Edited on 31/3/04 by jimgiblett]

No I am probably not making my own. I will probably buy one from Stuart Taylor or MK.

adam

Our flange too is almost the same... not too clear but you can see it!




Hope this helps!