Just thing of the winter mods, and contemplating a paddleshift system for the car.

I have most of the parts, but where can I get a collar that fits over the steering column from? Ie the bit that the actual paddle pivots around. - I already have the paddles themeselves.

Ps I do not have access to fabrication facilities.

cheers
Craig

mk?

i used a triumph sprint st handle bar .remove the bar and your just left with the clamp , tap 2,8mm holes in it top and bottom for your rose joints ,, turn down the steering stem and the handle bar fits over it and clamps tight

[Edited on 6/11/09 by OX]

I have the complete collar that fits over a Sierra column, from the AB paddle kit. It's basically a tube, two slits to adjust, and two oilite bushes TIG'd top and bottom taking M6 bolts to which the paddle set was simply bolted.
Unused, unabused. I fabricated my own for the much smaller Westfield column.
If this sounds like what you need, I'm happy to send a jpeg over to confirm.

Motorcyle_mayem. U2U sent.
cheers
Craig

Good grief! There's a lot of people out there.... stop hassling me.

I've sent a jpeg over in response to aka, I'll happily send one elsewhere, but just hang on a while.....