A nice cheap GEAR LEVER ADAPTOR just cut the pedal end off,and drill the clevis/rod end mounting hole in the blade.
NTDWM, it's just wkat I did

Shiny Gearlever

I used something very similar but mine was adjustable in length so even had holes already drilled along its length

Yea, my first attempt was with something along those lines, but I trimmed it down and it then wasn't long enough for the Klicktronic actuator.

Red gear lever

where did you get the crank assembly you are using?

The top crank/lever was from Pathfinder, he used to post on here, but seems to have gone AWOL pity, because he did some quality work, especially on paddle shifts. The pushrod is ZX9R-C.