Hi All,

Went over the r1 today,

Notice one of my thermostat inlet pipes had leaked and filled the top of the cycliner head moulding with coolant (about 2 cm deep)

look as if the pipe work is leaking between where it joins the block. looks like an O ring needs replacing.

Question is, where from???

also, anything I shoud be careful of? Looks liek the stat pipes (X2) just have one bolt intot he block and thats it.

drain water, undo bolt & pull pipe out. New sealing washers are availble at Yamaha dealers. I replaced mine in minutes.

just spoke with AB perfoamnce and ordered from a local motorcyle place (after being told on the phone they had them instock so i can collect)

shame as I would have liked to put the £3.50 andys way lol