anyone fit the k9 hayabusa engine..
mine arriving next week and i would love some info on the dos and donts of wiring
ie: what jumpers i need and were to fit resistors etc.....
iam going to be using the original wiring loom with the hayabusa clocks...
any info would be a great help as I am new to bike engines
Thanks in advance

im using a 2009 engine (same as 2010).

only problem Ive had so far is the throttle bodies are a little higher than a pre 2008 so not sure what im going to do about getting air into it.

mines not running yet though.

Wiring would be my biggest concern

Im no electrical engineer and Ive never wired anything but I appear to be getting on alright

I have a couple of files that maybe of use to you. I have the K9 workshop manual and I also have a full colour wiring diagram (its Australian though, but appears close enough that its useful).

Dont expect a massive amount of help of here. I think there is only 3 of us with this engine (could be wrong)

I will get these files for you later (will need to upload them somewhere as they are quite large)

Mike