Anyone think this colloector is worth a punt would be about £100 delivered from USA.
the manifold i'm making is 1.5"OD and this is the same so i'd need the ends expanding/swaging
the spec is 1.5" then 2" then 2.5" made from stainless

i can't really find anything over here that's close to that cost





[Edited on 23/1/11 by Johneturbo]

2.5" is quite a large bore. my s2000 install is using the same i/d

Collector design is critical to flow. Pipe sizes important. Lengths important.
Offer a quid and you have a cheap base for a rotary clothes line if you cement it in your patio.
p.s. I don't like it.

looks like the pipe ends are crimped to fit into the collectors and the collectors are made by squashing the larger tube, not liking the look of it either

fair point guys about the quality of it/ how it's made thats why i asked

Daniel, i didn't think 2.5" was that big for a link pipe


what about these found them on ebay UK £76 delivered, i'm after something just to get me rolling for now




ETA says ALUMINISED MILD STEEL does that mean will take a bit longer to rust


[Edited on 23/1/11 by Johneturbo]