Thanks very much to all who replied
... I hope for someone ... (but not a mechy like me)
In my kitcar I'm running a Suzuki Hayabusa with a stock Busa ECU and connected the Taco output to the STACK 8100 display, it reads the signal but
is twice the real value - I.e. At 1500rpm it reads nearly 3000rpm.
The STACK dash has been configured to 4 Cyls.
I'm guessing that the ECU feed needs to be corrected for the STACK input - does anyone know what the ECU puts out and what the dash receives? I
bought the dash from another kit car which had an R1 fitted.
Anyone come across this before ? OR, should i take the tach feed straight from the coil 1 ?
Any advice would be great,
Myd
I think you could try the setting for a 2 or 8 cylinder engine and that way it will read correctly.
[Edited on 5/2/11 by cosmick]
As above.
As above I run one and I use wasted spark so have to have it set as a two cylinder...
All sorted, changed the cyls to 2 and it worked...
Thanks very much to all who replied
quote:
Originally posted by MydT9
All sorted, changed the cyls to 2 and it worked...
Thanks very much to all who replied