Anybody used this lot?

http://www.lynxae.co.uk/Products-Bikesports.htm

I haven't used them but I have seen their race cars up close and have to say their engineering is very good.

Suggest you phone them and see how knowledgeable they are for your application

Roger.

Looks like a nice piece of kit.
Tony

I looked at that system a few years ago and spoke to them.

They were very helpful and more than willing to do the work to make it work for my car, at the time hey hadn't fitted one to a 7 before but they may well have by now.

I decided not to fit a reverse gear in the end, after all I didn't have to as my car had been through an sva and is light enough to push.

when my westie reverse gearbox finally decides to give up the ghost may well be tempted by this, then again it will be for reliability reasons as opposed to cost as i will have additional cost of upgrading to bailey morris 2 piece propshaft, centre bearing & its bracket to consider.

I wonder anyone been successful with a one piece setup??


[Edited on 12/3/11 by andyfiggy2002]