Are the modifications u need to do on the 2008 the same as the 04 /06 r1 Cam cover ?

As the read valves look a little different do I remove both the read valve and the curved plate? To leave just the the plate that holds them


breather

Also what size hole have u used to drill in in the cam cover and do u replace the steel baskets afterwards?
Pos 1 Block hole up
Pos 2 Drill breather hole


Cam cover


Is this all that's required to be done?

Kev..............

[Edited on 19-3-11 by Kev99]

Those look the same as my 06 ones. I removed both bits. blocked the holes at 1 (I used tapper pins, others have used grub screws) and drilled 5/16" holes at 2. I refitted the basket bits and put folded, fine ally mesh between them and the covers to condense oil vapour on so it drains back in.

Thanks for the reply thats what i will do then

Just looked differant from the pics ive seen on here

Kev.......

[Edited on 19-3-11 by Kev99]