as above wanting to fit a oil pressure gauge to my blade engine, can i just fit any i now i got to modify it it fit ,just need to now if i need a special gauge to fit the bike engine

Any oil pressure gauge will do.

If you get an electric one then you need to run the sender off a bit of hose, the engine vibrations will kill it otherwise.

The standard light sender sits in a big bung, you can undo this and tap to whatever your fitting is

I got this reply when I asked about the thread size on a 919 Blade.

The thread is M10 x 1.5 but it might be easier to remove the boss that it screws into and retap it 1/8 npt as most of the aftermarket senders use this. The boss can be removed from the main oil gallery using a 17mm socket but it is real tight usually. Be creful when refitting the boss as it is M2o fine and easily cross theaded

Cheers
Tony

In would go with a stack mechanical one. Not too expensive and good quality. I have one on my s2000 engined mnr

quote:

---

Originally posted by tony.g
I got this reply when I asked about the thread size on a 919 Blade.

The thread is M10 x 1.5 but it might be easier to remove the boss that it screws into and retap it 1/8 npt as most of the aftermarket senders use this. The boss can be removed from the main oil gallery using a 17mm socket but it is real tight usually. Be creful when refitting the boss as it is M2o fine and easily cross theaded

Cheers
Tony

---

well i spoke to andy at ab performance and he said if i send him my new sender when i get o ne will make me the full unit for me so i will do that

The answer above came from Andy.
Good luck.
I'll be interested how you get on as i want to put one in my car.