Board logo

help westy fireblade wont work
firebladetim - 28/5/12 at 10:30 PM

hello all
i have recently got a westfield megablade and have got some running problems with it.
When i first got it it run was quick but wasnt running at its best,on my third trip out in it i had gone about 3miles and it started to slow and drive like it was running 2/3 cyl and then stopped all together,when it cooled down it started but didnt run well,after changing coils,plugs,leads,and having the carbs cleaned tuned and balanced it runs fine in the drive way,went out to test it got about 1 mile and had very little power and then did same thing and stopped and this time didnt want to start again and still wont start even when cold,it is a 893,sausage filter,pump and regulator,does anyone have any ideas what it mite be any help would be great thanks

Chippy - 28/5/12 at 10:59 PM

Just been reading an article regarding a similar problem and that was caused by a faulty crank sensor, I have no idea if M/C engines have one though. Anyway HTH Ray

designer - 28/5/12 at 11:06 PM

Weren't we here this morning?

firebladetim - 28/5/12 at 11:10 PM

lol yes think i posted it in the wrong place

slingshot2000 - 28/5/12 at 11:12 PM

quote:
Originally posted by designer
Weren't we here this morning?


Hello ! Yes, I thought I saw this here earlier today, too!

Regards (?) or some other comment

Jon

ReMan - 29/5/12 at 07:04 AM

The double post police will get you