Just a quickie -
My Haynes does not mention a torque setting for the bolts that go through the clutch springs and pressure plate, into the inner basket.
Does this, therefore, mean very very tight?

Dont do em stupidly tight, cos you are bolting into aluminium and you might knacker a thread, but basically do them up until they bolt up tight against the inner basket.

Chris

(Looking at the timing of your post, have you been watching the footie too? LOL)

[Edited on 16/4/03 by ChrisGamlin]

Thanks Chris, thought so but always worth checking

Yep, watched the footy. As a Spurs fan, I would like to make it known that Henry was clearly offside, Ashley Coal is a hatefull little sh*t face and Sol Campbell deserves everything he gets.

That aside, it was a damn good match. I only wish Spurs were even half as good as either of 'em!!

cheers
tom