hi again all

well i now have the problem of my speedo not working

the set up im using is

original busa speed sensor on a bracket over the gearbox output shaft flange which i have fitted 2 tabs @ 12 oclock and 6 oclock for the speed sensor to pick up
im also using speedo healer and original busa inst/clocks

unfortunatly it aint working, i followed all the instructions to a tee but still nothing, no indication of any speed at all, i followed the test set up instructions of the speedo healer, it all works up until it asks you to spin the rear wheels to make the t for test mode flash, well it doesnt flash, but i can move the needle on the original busa clocks move about, so the speedo healer must be doing something

anyone else had this kind of problem or any solutions ?

much appriciated

cheers

Finlay

hi finlay you need two magnets at 180 dgrees and sensor flat side pointing to them

cheers

marc

ps.
this has worked on six busas so far that had no speedo working trying to use tabs as a trigger, i used etbs magnet that come with the digidash if you email me i can send you a couple in the post


cheers

marc

excellent

cheers Mark

i will send chris an email with my address

I set my original sensor to pick up on the propshaft adaptor flange bolts - worked a treat with speedo healer.

Doesn't seem to make a difference that the bolts are not equi-distant around the circumferance....

they dont need to be magnets , but make sure you dont use stainless

got the speedo healer working with magnets

cheers