Trying to fit an Acumen to a ST LOCOBLADE.

Using the Tacho feed, the speedo sensor from the fireblade engine. Car has no speedo so on the speedo sensor I am using a pos feed to one wire, one to earth and one as the sensor output

It recognises neutral but doesn't want to learn - any thoughts?

(company said fit a 10K resistor in pos feed)

They are a bitch to get to work m8 when it goes well its fine but not many get them to work reliably with blade engines...

Steve

Read this LINK
HIH



[Edited on 22-8-08 by Hellfire]

Oh dear good luck! I gave up with mine on an old Blade engine even after fitting the sensor kit supplied free from Acumen.......