The type 9 release arm doesn't fit and I thought I'd just trim it down and weld back up, but... what the hell is it made off? Hacksaw justs slips off without making a mark...
Is it hardened and should I shell out the £40 for the correct one??
Steve
I'm getting ready to replace the type 9 cast iron bellhousing with an RS2000 ali job..
The type 9 release arm doesn't fit and I thought I'd just trim it down and weld back up, but... what the hell is it made off? Hacksaw justs
slips off without making a mark...
Is it hardened and should I shell out the £40 for the correct one??
Steve
angry grinder?
The RS2000 arn is also set at a different angle, I found an RS2000 arm at the Fords parts department in Chelmsford for £25
Rescued attachment DSCN0876m.jpg
side view
Rescued attachment DSCN0877m.jpg
You may also need the older Capri release bearing CCT113 i think
steve,i can recommend a frame engineering they also sell bellhousings
http://www.rwdmotorsport.com/Bellhousings/Bellhousing-Accessories/RS2000-Clutch-Fork/prod_28.html