Can someone refresh my memory please and save me a search.
What holes need blocking up on zx9r carbs?? A piccie would be handy.

Have a look at: http://www.dynojet.com/pdf/2185.pdf

Cheers

Ian

It's the holes in line with the needle thats the hole boggs blocked in my zx9r/e carbs

Its the top brass holes in the photo

carbs on manifold

This is the first time i have heard this mentioned, i have yet to set my carbs up what would happen if i didnt do it?

quote:

---

This is the first time i have heard this mentioned, i have yet to set my carbs up what would happen if i didnt do it?

---

Thanks lads. Ill sort that tomorrow and hopefully my car will rev more freely. Got a long weekend this weekend to get it sorted and hopefully nearer sva, although iv lost saturday thanks to my dam missus informing me shes working so iv got my daughter.

Before Boggs blocked the holes in my carbs the fuel settings went week at high revs

I must advise you get it on a rolling road if i had not with it going week at high revs it may have damaged valves etc
Graham

[Edited on 7/5/08 by jacko]

Same holes need to be blocked on ZZR1100 carbs (or at least did on mine). Maybe its a carb make thing - ZZR's are keihin.

As Jacko says - rolling road. Mine ran better than old carbs, car felt great but was way to weak for long term use. After rolling road the change was brilliant. Boggs dont charge a lot for doing this.

Cheers i will make sure its done.

Cheers i will make sure its done.