Does anybody know what this manifold fits, its brand new and has been sat in my garage for years it came with the box of bits when i got my part finished kit.

looks like a twin 40 mount for a pinto

xflow

my is guess is xfow

looks like Xflow to me

Engine side looks like Pinto


[Edited on 18/5/08 by jacko]

[Edited on 18/5/08 by jacko]

i'd've said pinto too and it's upside down in the top picture

tom

[Edited on 18/5/08 by indykid]

Port spacings will confirm it, 92mmish (from memory) and it could be a CVH.

Bolt pattern looks Pinto.

After a bit of searching it looks like i was wrong (along with most of you)

Looking at the pics below you would have to guess on it being cvh judging by the odd stud spacing of the second two studs from the outside!

But i could still be wrong

Pinto inlet


Xflow inlet



CVH inlet

oooooooh, good call.

i'd like to change my bet to CVH.

the top holes on the pinto gasket are in line with the top of the ports. on the cvh, they're clear above which matches with the manifold in question..........but the gasket looks to have oval ports, the manifold has round.

bloody close though. i didn't realise the 3 were so similar.

tom

[Edited on 18/5/08 by indykid]

Almost certainly CVH. Have one on me mo'a.

I think you are right,i had a think about it last night and i sold a set of 40,s a couple of years ago and they were on this manifold which was for my cvh, and there was also a mystery manifold which turned out to be a pinto one that i sold with them i that makes any sense!
I was thinking this was the mystery manifold.
Thanks guys.

pinto.

spot t he difference; taken from burton power.


the casting number will tell you something too.