INDY BIRD
|
| posted on 30/11/14 at 06:03 PM |
|
|
help fitting power commander on zx12r B mod 2004
Hi all
fitting the power commander tonight on the zx12r B engine 2004 and cannot locate 1 plug,
loom is cut about a bit so not sure if he has cut it off?
in the instruction see link its fig C on page 2 2pin connector,
link
http://www.surfsidemoto.com/images/KawZX12R0405.pdf
I would like to know what this does as its not described in the instructions it just says disconnect this plug,
any ideas what it does and the colour of the wires????
Thanks for any help
Sean
[Edited on 30/11/14 by INDY BIRD]
|
|
|
|
|
CosKev3
|
| posted on 30/11/14 at 07:13 PM |
|
|
Figure D says you put the power commander in line between the two white connectors!!! 
|
|
|
INDY BIRD
|
| posted on 30/11/14 at 07:16 PM |
|
|
you are correct only problem is i cannot locate this white connector hence reason for asking what its for and what color wires it has in case the
connector has been cut of the loom etc,
so wondered if anyone new what it does or supplies to try to chase it in the loom
Thanks for the reply
|
|
|
CosKev3
|
| posted on 30/11/14 at 07:20 PM |
|
|
What wires come off the red power commander plugs?
Is it just a power connection?
What does the power commander do now without the red plugs in place?
|
|
|
CosKev3
|
| posted on 30/11/14 at 07:44 PM |
|
|
Googling the power commander it shows there are a red and a black wire out of the red plugs?power and earth I would guess?
So I reckon its not important it goes between the white plugs, that is just a easy place to pick them up on the bike loom?
|
|
|
INDY BIRD
|
| posted on 1/12/14 at 04:21 PM |
|
|
now sorted connected into another switched live
thanks for replies
|
|
|
