ch1ll1
|
| posted on 13/4/08 at 08:27 PM |
|
|
r1 fuel light flashing and 8k bounce
hi all ,
has anybody found a good way to get round the fuel light and the 8k rpm bounce? ( on a 4xv r1 )
looked on here tried shorting the fuel sender, fitting a resister, and using my fuel sender in the tank,
just the same,
also tried a spare ecu,
any ideas?
cheers Paul
[Edited on 13/4/08 by ch1ll1]
|
|
|
|
|
nitram38
|
| posted on 13/4/08 at 08:43 PM |
|
|
I thought you got the 8k bounce from lack of exup?
Have you wired the fuel light up to the pump?
The pump has a connection for the level warning.
Maybe you are getting the warning because it is disconnected?
[Edited on 13/4/2008 by nitram38]
|
|
|
Davey D
|
| posted on 14/4/08 at 08:10 AM |
|
|
I have a 5VY, so it may be different. but when i ground the fuel level warning signal through a 750 Ohm resistor the light goes out.
The light doesn't go straight out... its like it has a cycle of flashes, then once its done the cycle it goes out.
|
|
|
ch1ll1
|
| posted on 14/4/08 at 06:54 PM |
|
|
im using an r1 loom,
using r1 pump,
exup is 7500, fuel sender is 8000
the bike is carb not injection
cheers paul
|
|
|
Coose
|
| posted on 14/4/08 at 08:02 PM |
|
|
I used a 10k resistor on my 5JJ as it was all I had kicking around and it worked a treat!
Spin 'er off Well...
|
|
|
locoboy
|
| posted on 15/4/08 at 05:58 PM |
|
|
I Just wired them straight together and it was fine. although the fuel light was on all the time. Nothing that a piece f black insulation tape wont
cure. 
Mine was 4xv using R1 loom and R1 clocks too.
Give it a try.
ATB
Locoboy
|
|
|
ch1ll1
|
| posted on 25/5/08 at 08:36 PM |
|
|
still flashers and 8k bounce.
even fitted r1 fuel sender, still same,
any ideas?
cheers paul
|
|
|
