uberf1end
|
| posted on 16/4/03 at 09:13 PM |
|
|
Fireblade Clutch Torque Setting
Just a quickie -
My Haynes does not mention a torque setting for the bolts that go through the clutch springs and pressure plate, into the inner basket.
Does this, therefore, mean very very tight?
|
|
|
|
|
ChrisGamlin
|
| posted on 16/4/03 at 09:23 PM |
|
|
Dont do em stupidly tight, cos you are bolting into aluminium and you might knacker a thread, but basically do them up until they bolt up tight
against the inner basket.
Chris
(Looking at the timing of your post, have you been watching the footie too? LOL)
[Edited on 16/4/03 by ChrisGamlin]
|
|
|
uberf1end
|
| posted on 17/4/03 at 11:31 AM |
|
|
Thanks Chris, thought so but always worth checking
Yep, watched the footy. As a Spurs fan, I would like to make it known that Henry was clearly offside, Ashley Coal is a hatefull little sh*t face and
Sol Campbell deserves everything he gets.
That aside, it was a damn good match. I only wish Spurs were even half as good as either of 'em!!
cheers
tom
|
|
|
