richwill
|
| posted on 28/12/19 at 11:53 AM |
|
|
4age installation parts
I’m looking to upgrade my Luego Velocity this winter by removing the pinto and fitting 4age 20v. I’m looking for parts to help with this. I have
listed below what I need
Exhaust system
Ecu/ management
Wiring loom
Does anyone have any parts lying around or can point me in the right direction to get them.
|
|
|
|
|
JonBowden
|
| posted on 28/12/19 at 02:47 PM |
|
|
not sure if this helps much but the 16 and 20 valve exhaust systems are very similar (except for one mounting hole being moved by a few mm).
I am planning to make my own using a flange plate from Danst engineering.
Jon
|
|
|
1960dave
|
| posted on 29/12/19 at 11:30 AM |
|
|
I have a 16v exhaust manifold spare left over from my westfield conversion plus a 16v exhaust flange both in stainless.
|
|
|
JonBowden
|
| posted on 29/12/19 at 01:19 PM |
|
|
Richwill, If you don't buy Dave's manifold, I might be interested
Jon
|
|
|
JonBowden
|
| posted on 29/12/19 at 01:47 PM |
|
|
What are you doing for the gearbox, bellhousing and clutch?
Jon
|
|
|
richwill
|
| posted on 29/12/19 at 01:54 PM |
|
|
Dave I would be interested in the manifold and plate. Please message me about price etc
|
|
|
richwill
|
| posted on 29/12/19 at 01:56 PM |
|
|
Jon
I have a T9 gearbox with correct bell housing and clutch
|
|
|
1960dave
|
| posted on 29/12/19 at 04:43 PM |
|
|
quote:
Originally posted by JonBowden
What are you doing for the gearbox, bellhousing and clutch?
I am using a ford type 9 box with a Raw bellhousing ( Paul Woods of Woodsport has one for sale). I am using a aw11 flywheel with a aw11 clutch cover
and a ford 2.0 pinto clutch plate. I did have a omex to run the timing and weber carbs
|
|
|
JonBowden
|
| posted on 30/12/19 at 11:51 AM |
|
|
What do either of you use for the spigot bearing?
Jon
|
|
|
1960dave
|
| posted on 30/12/19 at 12:14 PM |
|
|
I have a couple of spare bearings if you need one
|
|
|
