Your the first person to have done that thank god some one has!! did you use the trigger marks on the flywheel for the EUC or did you put a trigger wheel on the front of your engine.



Allan

just use marks on flywheel,its the same as 2.0 just about 1/2 the weight

watch the position of the trigger, Make sure if using the manual flywheel you have the bracket for the tigger from the a maunal engine. as they are different positions


If I remember correctly the manual trigger sits closer to the block the auto sits very close to the ringgear.

Thanks conrodkid, I can now start looking at other reasons why this engine will not run.

quote:

---

Originally posted by Scoobylav
Just dont get a dunnell lightened one as the "teeth" on it arent good enough to trigger the sensor properly .. . . . . . in my experience.

---