Board logo

WTD: Stainless Steel exhaust offcuts and parts
l0rd - 2/11/10 at 09:10 PM

In order to create the tintop exhaust on my previous post i am after some offcuts if you have any before i go on ebay or I need ideas of where i can find these as cheap as possible.

Cash waiting.

Stainless steel parts:

2 x 15cm 3"OD straight through pipe
80cm of 1"3/4 OD straight through pipe
Y piece collector 2-1 inlet 1"3/4 OD outlet 2" OD
2 X Flat bar 30mm X 2mm X 500mm
2 X Square plates 100mm X 100mm X 2mm

snapper - 2/11/10 at 09:15 PM

Agricultural dairy pipes

ahunt - 2/11/10 at 09:19 PM

Hey,

I can get the 2mm flats for you if you like? I have to go to the steel store tomorrow so ill pick them up if you want?

Adam

l0rd - 2/11/10 at 09:25 PM

quote:
Originally posted by ahunt
Hey,

I can get the 2mm flats for you if you like? I have to go to the steel store tomorrow so ill pick them up if you want?

Adam


Thank you very much for the offer. Let's see if anyone else has some that want to get rid off and i will u2u you later to tell you.

ahunt - 2/11/10 at 09:28 PM

Ok no problem itll only be pennys and to post

hughpinder - 3/11/10 at 09:15 AM

I can let you have 63.5 od *1.5 thick stainless pipe, but its 316 grade.

Regards
Hugh

l0rd - 3/11/10 at 10:17 AM

quote:
Originally posted by hughpinder
I can let you have 63.5 od *1.5 thick stainless pipe, but its 316 grade.

Regards
Hugh


Thank you for the offer.

I will keep you in mind. I have just found one company that they can supply everything. I need to ring them to see if they can only provide the lengths that i need.

I was thinking that instead of a Y piece 2-1 collector to use some 63mm pipe and then make it oval to fit 2 38mm ones. The maths do add up fingers crossed.