Board logo

Zx 12 sump baffle plate
belgian2b - 27/5/11 at 06:12 PM

Hello,

I am rebuilding my zx12 engine.
I was looking for a sump baffle plate and this is the only i have been proposed :


http://www.novaracing.co.uk/kawasaki-zx12-rotating-pickup-sump.htm

I am not planning to buy the dry sump kit, but only the sump baffle plate.

What do you think ot this ??


Gerardo

[Edited on 27/5/11 by belgian2b]

imp paul - 27/5/11 at 06:51 PM

i have the full kit above and its very very nice also a must for a bec for a long life engine its your call cheers paul

eddbaz - 27/5/11 at 07:36 PM

I run that sump setup the same as paul, worth the expence in my opinion, also the sump is very shallow and it doesn't purtrude below the chassis rails.
If your going to use a modified standard sump than the baffle plate shown can be used.

belgian2b - 27/5/11 at 08:34 PM

Plate ordered !!


Gerardo

Breaker - 27/5/11 at 10:02 PM

quote:
Originally posted by belgian2b
Plate ordered !!


Gerardo


Where did you order? Can you post the link ?
Interested in a baffle plate too !

belgian2b - 28/5/11 at 07:03 AM

Hello,

i placed my order at Nova racing.

here is the e-mail address i received the quotation :


cad@novaracing.co.uk


price : 75 £ + delivery cost + vat ( this only for the sump baffle palte).






Gerardo

belgian2b - 7/6/11 at 07:37 PM

Hello,

me again !!

i received today my sump baffle plate from NOVA.

i have one last question : what should i do with the breather tube that goes deep in the sump ?
there no hole in the baffle plate to let it pass.
Should i just cut it jus t over the baffle plate or should i remove it ?

thanks for your advice,

Gerardo