Damon Hill
|
| posted on 8/4/11 at 02:40 PM |
|
|
BMW 316 engine
I've bought a 316 donor for my locost, i wanted to use the engine, but i'm starting to worry that it's too big. Anyone else used a
316 engine for their project?
|
|
|
|
|
Miks15
|
| posted on 8/4/11 at 02:56 PM |
|
|
i am, but not in a locost, slightly different chassis shape, i reckon it will fit in the haynes chassis
|
|
|
Miks15
|
| posted on 9/4/11 at 07:31 AM |
|
|
Sorry that probably didnt sound very useful, was having a boring day at work.
Let me start again.
Im using a 316 engine in my build. I initially had a standard locost chassis which i bought online. Then engine looked VERY tight. The chassis i had
bought was twisted so i never really looked further into if it could actually be made to fit, but i reckon chassis rails would be right in the way of
the exhaust ports (the engine leans over quite a bit).
So what i did was make a custom chassis based generally on the book and haynes car, but with differences in the engine bay, you can see some in my
archive. This allowed plenty of room and allowed me to get the engine quite far back for better weight distribution. The engine leans over on the side
that the steering will go down so you will need a dog leg in your steering to get around the manifold.
If you havent got a chassis yet id recomend seeing if the engine will fit in the haynes chassis (wider and taller than the book) and going for
that.
Hope this has been a bit more helpful, if you want to know anything else, just u2u me.
Mikkel
|
|
|
Damon Hill
|
| posted on 9/4/11 at 09:44 AM |
|
|
Thanks, that's very helpful, i will look into the measurements.
Ben
|
|
|
Miks15
|
| posted on 9/4/11 at 05:37 PM |
|
|
If you want any measurements of the engine (dont know if yours is accessible yet) give me a shout and ill measure them up.
Also if you need any tips on stripping the donor im here to help
|
|
|
