shaun one
|
| posted on 15/7/05 at 05:18 PM |
|
|
new build
Hi guys ,just a couple of questions.when useing a sierra for the donor car and all is stripped ,i will be useing the front hubs discs and callipers
?,yes.Will i be useing the sierra track rod ends or are the swivel joints in the book compatible,the reason i ask this quistion is that i want to fab
up the wishbones .will a ball joint from the austin maxi fit the sierra hub . Thanks for all the replies to previous ?.
|
|
|
|
|
Danozeman
|
| posted on 15/7/05 at 05:24 PM |
|
|
Hi mate. 1st you will have to have the bottom taper machind on the upright to take the maxi taper. Most Kit car places will do this.
2nd. the sierra rack is longer so youl have to have it shortened. Best bet is to use a Mk2 escort rack and rod ends as i dont thing the sierra rod
ends fit. Depending on what kit u have. Think they all use mk2 escy except the luego viento. I stand corrected on this bit though.
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
tks
|
| posted on 15/7/05 at 07:04 PM |
|
|
you can also do the mod your self
search for the alixter tool number on the forum..
if you life far away from an kitkar manufacturer..
and if you build at night.
Tks
[Edited on 15/7/05 by tks]
The above comments are always meant to be from the above persons perspective.
|
|
|
Avoneer
|
| posted on 15/7/05 at 08:59 PM |
|
|
And you will have to have shorter top wishbones.
Pat...
No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.
|
|
|
shaun one
|
| posted on 15/7/05 at 09:10 PM |
|
|
new build
Thanks for the reply s will get there in the end im sure.Also do i make the suspension mounting brackets to the book 48mm wide is this ok as i intend
to buy nylon bush set from lolocost does anybody know the diameter of there bushs,cheers ,shaun
|
|
|
NS Dev
|
| posted on 21/7/05 at 01:06 PM |
|
|
sierra and mk2 escort track rod ends are the same thread
|
|
|
%20(WinCE).JPG)
