RK
|
| posted on 6/1/10 at 01:11 AM |
|
|
CA18DET not running
Starts in limp mode: no MAF plugged in. Does not start with MAF plugged in.
Prior to going out and blowing $100 to $550 on a new MAF, does anyone have any suggestions?
I have tried spraying carb cleaner in the MAF; the coolant temp sensor is plugged in etc.
Thank you in advance.
PS there are no lights on my ecu, so I can't check codes.
|
|
|
|
|
vorn
|
| posted on 6/1/10 at 07:23 AM |
|
|
Are you running the standard ECU ???
|
|
|
vorn
|
| posted on 6/1/10 at 07:46 AM |
|
|
just found this
|
|
|
vorn
|
| posted on 6/1/10 at 07:47 AM |
|
|
air flow meter
|
|
|
turboben
|
| posted on 6/1/10 at 08:48 AM |
|
|
I've got a pdf of the workshop manual if its any use?
Ben
|
|
|
RK
|
| posted on 6/1/10 at 02:02 PM |
|
|
Thanks Vorn! I don't know why I didn't think of looking through the pdf (which I have). I'll try that!
Standard ECU for now. I plan on ditching this for MS.
[Edited on 6/1/10 by RK]
|
|
|
vorn
|
| posted on 6/1/10 at 07:16 PM |
|
|
If you have any problems , I have a few factory ECU's and a couple of "chiped ones from 350HP setups .
It wolud be good if you had one with the fault lights as the code system is very good and lets you know what is going on .
Cheers
Vaughan
|
|
|
