Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: 3m x 3m shed
Volvorsport

posted on 10/7/16 at 10:52 AM Reply With Quote
3m x 3m shed

As the title says , wanting to build a 3m square shed on the back of my new garage . I can buy a steel one for approx 500 quid . Struggling to get under that for timber unless I use reclaimed pallets / scaffold boards. It's only 3 sided . Any suggestions or pointers greatly appreciated

Ta





www.dbsmotorsport.co.uk
getting dirty under a bus

View User's Profile Visit User's Homepage View All Posts By User U2U Member
hizzi

posted on 10/7/16 at 11:32 AM Reply With Quote
have you priced using timber kit sheething ply. 2.4x1.2 sheet around£10
View User's Profile View All Posts By User U2U Member
ian locostzx9rc2

posted on 10/7/16 at 11:34 AM Reply With Quote
Buy the wood and build it your self wouldn't cost £500 quid 3by3 inch frame external ply roof external ply sides or cladding I did it many years ago to the back of my pre fab garage .
View User's Profile View All Posts By User U2U Member
JoelP

posted on 10/7/16 at 08:29 PM Reply With Quote
I'd be surprised if external ply was good enough. Would need treating.






View User's Profile View All Posts By User U2U Member
ian locostzx9rc2

posted on 10/7/16 at 08:39 PM Reply With Quote
I made mine with a 3 by 3 frame ply roof with roofing felt and shed cladding planks
View User's Profile View All Posts By User U2U Member
loggyboy

posted on 10/7/16 at 08:43 PM Reply With Quote
Im half way thru doing a fairly sturdy 4x2 timber shed from scratch. Spent about 450 to date on frame, panels, paint and screws/ironmongery, and budgeting for a further 2-300 on conc base, osb/felt roof and glazing.





Mistral Motorsport

View User's Profile View All Posts By User U2U Member
nick205

posted on 11/7/16 at 08:02 AM Reply With Quote
I'd have thought 4x2 timber frame roofed with exterior ply and felt with sides clad in overlapping horizontal exterior feather edge planks. Material cost must be sub £500 and build it yourself - finish it with an exterior grade fence type sealant and perhaps guttering to control rainwater flow. For my money a hardcore and concrete base would have to go down raising the shed off the soil to prevent rain soaking in and give you a solid floor.






View User's Profile View All Posts By User U2U Member
ste

posted on 11/7/16 at 12:45 PM Reply With Quote
I had the same space so built this;

started by using some treated rails screwed to the fence posts

Description
Description


Description
Description


Then screwed onto that some 15mm OSB3 sheets which are external structural grade

Description
Description


3 x 2 studding to make the roof

Description
Description


Description
Description


Visqueen down and 3" of concrete poured.

Roof sheets are reclaimed ones from a farmer friend

Description
Description


Description
Description


Studding used to make a frame at the front

OSB screwed to the inner front wall

Description
Description


Then front covered with shiplap and painted with cuprinol wood paint. Door made the same way.

Here's the finished article

Description
Description


Not too sure on cost but probably under £500

View User's Profile View All Posts By User U2U Member
ste

posted on 11/7/16 at 01:00 PM Reply With Quote
Description
Description

View User's Profile View All Posts By User U2U Member
Volvorsport

posted on 11/7/16 at 09:07 PM Reply With Quote
Nice one.





www.dbsmotorsport.co.uk
getting dirty under a bus

View User's Profile Visit User's Homepage View All Posts By User U2U Member
MikeR

posted on 11/7/16 at 09:17 PM Reply With Quote
My biggest (only) concern with that is the water running off the roof into the gap between the fence / side. It will get wet and have no way of drying out.
View User's Profile View All Posts By User U2U Member
ste

posted on 11/7/16 at 10:00 PM Reply With Quote
quote:
Originally posted by MikeR
My biggest (only) concern with that is the water running off the roof into the gap between the fence / side. It will get wet and have no way of drying out.


will have a gutter at some point into a water butt

View User's Profile View All Posts By User U2U Member
nick205

posted on 12/7/16 at 08:59 AM Reply With Quote
quote:
Originally posted by ste
quote:
Originally posted by MikeR
My biggest (only) concern with that is the water running off the roof into the gap between the fence / side. It will get wet and have no way of drying out.


will have a gutter at some point into a water butt [/quot

From experience gutters and rainwater control are necessary. Wet wood rots quickly and the interior space can get wet too.






View User's Profile View All Posts By User U2U Member
Rosco86

posted on 12/7/16 at 12:16 PM Reply With Quote
careful with the metal sheds as the condensation can be a nightmare!





My Build Thread

View User's Profile View All Posts By User U2U Member
Volvorsport

posted on 22/7/16 at 05:22 PM Reply With Quote
Well. I answered my own question and bought 10 pallets from work for a fiver. 2.5m long 1.25 wide. We get them with full size stainless sheet for the laser machines





www.dbsmotorsport.co.uk
getting dirty under a bus

View User's Profile Visit User's Homepage View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.