A little progress on the inside....the tank and twin tunnel covers are due to ship today so should have these views for real next week. It's amazing how much stuff depends on other stuff....To do the final build the chassis must painted...before that it must be finish welded...before that every bracket must on...before that every bolt on component must be obtained or have good measurements of....etc...etc... of course you guys already know all this......oh well won't be long now..

BTW the rear seats/tank cover moulding probably wont be C/F...it just looks nice on the rendering....

Inside Tiki 01


Inside Tiki 02


[img][/img]

Looking excellent a very innovative project.

Only a suggestion but how about a little more triangulation on the floor either side of the drivers seat? Also have you considered a forward brace for each roll bar on to the side protection bar?

Steve

Nice work
Did you know your right rear tyre is the wrong way round

how about?
Rescued attachment car.jpg

Thanks for the feedback guys. Some good ideas there.

Re: triangulation in general, there are definitely extra tubes still to go in...many will be figured after essential stuff has gone in.

Howlor, I did consider the forward braces from the roll bars but previous concensus voted no to those. However, I do still have the tubes. See below.

Tiki side

Speedyxjs, Ooops...I do hope they actually fitted two of each way round....they are all the same wheel so I will just have to put the correct ones on the right places.

Whippy, good ideas...I will have to check as to how practical they will be and if they clash with my own triangulation plans..

I like the forward bracing.

See lotus 2-11 (avatar)

I knew I had seen it somewhere else!

Steve

I think it's looking fantastic.

Looking good Alan, shame the tank wont be carbon fibre

All being well should see you in a month or so..........................will it be ready then?

quote:

---

Originally posted by skydivepaul
Looking good Alan, shame the tank wont be carbon fibre

All being well should see you in a month or so..........................will it be ready then?

---

quote:

---

Originally posted by Alan B

quote:

---

Originally posted by skydivepaul
Looking good Alan, shame the tank wont be carbon fibre

All being well should see you in a month or so..........................will it be ready then?

---

Yeah, of course it will......

See ya soon....

---