Board logo

wheel spacers
gy351100 - 30/10/09 at 04:36 PM

Hi all

I have a pair of 19mm wheel spacers to fit an English axle.
The problem I have is there is not enough space between the hub and the brake back plate to fit the extended studs.
It seems i would have to withdraw the hub/drive shaft by about 20mm.
Has anyone had this problem before.
Cheers

Keith


austin man - 30/10/09 at 04:42 PM

ideally remove the hub as they need to be driven home onto the splines


blakep82 - 30/10/09 at 04:51 PM

quote:
Originally posted by austin man
ideally remove the hub as they need to be driven home onto the splines


they can also be 'pulled through' with washers and an old wheel nut can't they?

but yeah, the shaft really ought to come out in any case


MikeRJ - 31/10/09 at 09:21 AM

quote:
Originally posted by blakep82
they can also be 'pulled through' with washers and an old wheel nut can't they?



I've had ones so tight that tightening them as much as I dare still wouldn't fully seat the splined section, they should ideally be pressed in.