malakiblunt
|
| posted on 30/9/04 at 10:42 PM |
|
|
new mid engined build site
hi guys if any ones intrested
ive just started a build site for my mid engined bec.
cheers
philip
|
|
|
|
|
mookaloid
|
| posted on 1/10/04 at 05:03 AM |
|
|
might be......where is it?
Ah just seen your next post I'll have a look
[Edited on 1/10/04 by mookaloid]
|
|
|
ceebmoj
|
| posted on 3/10/04 at 09:00 PM |
|
|
just had a quick look are you planing on manafacturing youer own calipers or wher the mols just the for checing for clerence?
Blake
|
|
|
Mark Allanson
|
| posted on 3/10/04 at 09:20 PM |
|
|
If you are going to make you own calipers, base the pickups on some thing production, that way make 100 and sell 99 to recoup the cost - I am sue
there will be takers here!
If you can keep you head, whilst all others around you are losing theirs, you are not fully aware of the situation
|
|
|
Peteff
|
| posted on 3/10/04 at 10:16 PM |
|
|
Solid axle !!!
You'll be off at the first corner unless you lift the inside wheel clear of the ground. Sorry but that idea is a non starter and with 10"
wheels it'll top out around 50mph unless you get some custom sprockets made, but the rear one will probably be bigger than the wheels. I fear
you have some serious grief ahead of you but hope you persevere.
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
|
